Tagged With "Heki Skylight"
Reply
Re: WeBoost (Wilson Electronics) Drive 4GM Cell Signal Booster
Nutman you raise a good issue. I actually have a small junction box on my roof for this purpose, I got two mending rods and screwed them in and then put a little silicone behind them to hold them away from the junction box, then I just slide the antenna into this gap which holds it securely in place. When I stop somewhere I open my sky light, stand up on the bed, and drop it into the holder. When I leave somewhere, I reverse the process - that way it's not sticking out way above my camper on...
Reply
Re: The Greatest Tool
Glenn, thanks for the "check six" on looking up. Cathy and I are out at our trailer prepping it for our upcoming two month trip to Canada. I checked my email, saw yours and stopped work on the trailer to read it. I just finished an inspection if the bathroom and looked up. The screw for the front right snap for the insulated vent fan cover was just about ready to fall out! I have checked all the interior upper screws, thanks!
Reply
Re: The Greatest Tool
I tend to forget to "look up" (unless it's an aircraft flying overhead). I noticed both my Fantastic Fan and skylight used these screws. ALL the screws were very loose, so were the additional Phillips screws in the Fantastic Fan. Don't forget to LOOK UP!
Reply
Re: Fiberglass repair
Some thoughts for a would be DIY home fiberglass worker. For years I have done small fiberglass repairs on things like motorcycle fairing, our boat, and even building a MH skylight with it. It is easy, inexpensive, and for the most part, forgiving to work with. Then we got a MH that had a fiberglass roof with a several surface cracks that didn't leak, but according to the fiberglass expert I had look at it, compromised the integrity of the roof. It was a much larger fiberglass project than I...
Reply
Re: 2013 Lance 2385
Our 1885 is listed as a 2014, but was built in 2013. Our slide very likely is the same as your 2385. What are you needing to know? We did have to have the slide bolted into the wall as it had an issue with the frame pulling away from the outer wall. We did lighten the load in the drawers to less than 50 lbs each, which is what Lance recommends, this includes the outer storage area. Otherwise, we haven't had problems with it. Attached is Lance's 2013 brochure that may give you some info.